#Download counter 1 6 zip

To cancel the operation, issue a 'bot_nav_begin_area' command again.Ĭreates a new nav area between the currently marked area and the currently selected area, and bidirectionally connects the new area. 'bot_nav_end_area' marks the opposite corner of the area and creates it. 'bot_nav_begin_area' marks one corner of the area. These two commands allow the creation of new nav areas. However, for some 'jump down' areas, the bots can move one way, but cannot get back the other.ĭisconnects ALL connections from the currently marked area to the currently selected area. For most areas, you will want to connect the areas in both directions. The merge will only occur if the two areas are the same size along the merge line.Ĭreates a ONE WAY link from the currently marked area to the currently selected area, telling the bots they can walk FROM the marked area TO the selected area. Merges the currently selected nav area and a previously marked nav area into a new, single nav area. Splits the currently selected nav area into two new nav areas, along the white split line. Marks the currently selected nav area for later operations. It is recommended that these commands be bound to keys for ease of use while editing.ĬAUTION: There is no 'undo' operation. Rogue bots just 'run and gun', and will respond to all radio commands with 'Negative'.Įach of the following bot_nav_ commands operate on the navigation mesh, allowing hand-tuning of the automatically learned data. If nonzero, allows bots to occasionally 'go rogue'. If zero, the bots will not buy or use the given category of weapon. If nonzero, the bots will wait to join the game until at least one human player has joined.Īll of the 'bot_allow' cvars can be either 0 or 1. This is useful for 'clan-tagging' bots.ĭetermines which team the bots will join. Will be prefixed to all subsequently added bot names. If a bot is kicked, a new bot will be added to maintain the quota. Setting this cvar to a nonzero value will cause the given number of bots to be maintained in the game. Difficulty values higher than 3 are reset to 3. Zero = easy, 1 = normal, 2 = hard, 3 = expert. This cvar determines the difficulty of all newly created bots (existing bots will retain the difficulty setting they were created with). These commands are shortcuts that set the bot_allow_* cvars accordingly. This command takes either the name of a bot, or the keyword 'all' - causing all bots in the game to be kicked. This command takes either the name of a bot, or the keyword 'all' - causing all bots in the game to be killed. 'bot_add_t' and 'bot_add_ct' forces the bot onto the respective teams. 'bot_add' will add a bot to the team specified by the 'bot_join_team' cvar. To change this bring up the console and type:Ĭauses a bot to be added to the game. If you prefer the console, commands are listed below.īy default the command menu is bound to 'H'.

Pressing 'H' will bring up the command menu.

This is done either with the console or by pressing 'H'. Now you will need to add the bots to the game. You have now installed Zbot! Now just start Counter-Strike, make a New Game.

You will be asked to replace some files, including liblist.gam.

#Download counter 1 6 zip

Unzip the entire content of the zip to your Counter-Strike folder. Either backup your entire cstrike folder or just the file 'liblist.gam' (this is where the changes are made). Z-bots offers different commands including adjusting bot difficulty levels, weapons, controls, numbers, navigation commands, and more.īefore You start installing Zbot it might be a good idea to backup your current settings just in case.